Audio Technica Desk Stand Microphone ATND8677

Audio Technica Microphone Desk Stand with Dante™ Network Output ATND8677 AUDIO SYSTEM
   
Specification
    • Connects directly to network via Ethernet cable – no need for expensive audio cable or soldering
    • Integrated user switch controls talk/mute in Local mode and triggers Dante-enabled devices in Remote mode
    • 3-pin XLRF-type in for quick mounting of gooseneck microphone
    • Red/green LED indicator
    • Local or remote control of mic gain, low-cut filter, LED indicator and 12V phantom power
    • Powered by network PoE
    • Scalable across Dante’s 512 bidirectional audio channels
    • UniSteep® filter provides a steep low-frequency attenuation to improve sound pickup without affecting voice quality
    • Heavy die-cast case and non-slip silicone foam bottom pads minimize coupling of surface vibration to the microphone
FREQUENCY RESPONSE 20-20,000 Hz
LOW FREQUENCY ROLL-OFF 80 Hz, 18 dB/octave
IMPEDANCE 1.4 kΩ
MAXIMUM INPUT SOUND LEVEL -10 dBu @ +30 dB gain
-20 dBu @ +40 dB gain
-30 dBu @ +50 dB gain
SIGNAL-TO-NOISE RATIO 68 dB, 1 kHz at 1 Pa
POWER REQUIREMENTS PoE IEEE802.3af standard (Power consumption 1.5W)
SWITCHES Local Mode: Touch-sensitive capacitive-type user switch function: toggle (mute on power up), toggle (talk on power up), momentary on, momentary off;
Low-cut filter: flat, roll-off;
Gain: +30 dB, +40 dB, +50 dB;
Phantom power: 12V DC, off
Remote Mode: Low-cut and Gain via third-party software*
WEIGHT (MICROPHONE) 770 g (27.2 oz)
DIMENSIONS 133.0 mm (5.24″) maximum length,
93.8 mm (3.69″) maximum width,
46.2 mm (1.82″) maximum height
OUTPUT CONNECTOR

Physical level: standard Ethernet

Input Connector: 3-pin XLRF-type