Miniature Surface-Mount Contacts
- Miniature “flange type” surface-mount magnetic contacts are perfect for sliding doors and windows where space is limited
- Screw or adhesive mount (Mounting screws and adhesive backing tape included)
- Mounting flange breaks off for extra miniature size
- High-impact weatherproof brown ABS plastic case
- Contact reed switch is SPST, deactivated rhodium on gold under-plating, for a long life
- 15″ (38cm) leads extend from side of switch
- 3/4″ (19mm) Gap
- Lifetime limited warranty
- White also available!
Overhead Door Magnetic Contacts
- Used for overhead doors in both industrial and residential situations where a wide gap is present
- Adjustable to fit most door-channel widths
- Switch contained in curved low-profile cast-aluminum housing for surface mounting on garage floor
- Magnet enclosed in epoxy compound inside aluminum case for direct installation to garage door with no projecting bracket to break or serve as a handle
- 23/4” (70mm) Gap
- 24″ (61cm) wire leads enclosed in armored cable
- Contact reed switch is SPST, deactivated rhodium on gold under-plating, for a long life
- (For NO/NC circuits, use SM-226R-3Q)
ViTRON™ Plus Acoustic Glass Break Detectors
- Supply voltage: 9V-16V DC
- Current consumption (typical): 7.5mA
- Operational temperature: -20°C to 60°C
- Maximum humidity: 95% non-condensing
- Sensitivity setting: Dual stage potentiometer
- Tri-color LED indicator: Orange-over-sensitive, green: alarm & correct calibration, red: under-sensitive
- Contact ratings:
- Alarm relay: 100mA at 24VDC, NC, Optorelay
- Tamper relay: 500mA at 24VDC, NC
- Reed relay: 100mA at 24 VDC, NC
- Alarm Time: 2.5 seconds
- Latching modes: Any or first to latch operation modes
- Max No. of units on Any Latch loop: 80
- Max No of units on 1st to Latch loop: 10
- False alarm protection: Digital microprocessor signal processing and noise reduction with maximum ground plane
- Electrostatic discharge: No false alarms up to 8kV
- RF immunity: 40 V/m from 80MHz to 1GHz
- Enclosure material: Flame retardant ABS
- Enclosure dimensions: 25x28x95mm for the detector, 10x12x58mm for the magnet
ShockTec™ Plus Digital Shock Detector
- Digital Microprocessor with Intelligent Digital Signal Processing
- Gross Attack detection
- Incorporates a door/window magnetic contact for shock and contact protection (separate zones)
- Attempts to defeat the contact with large magnets cause a tamper alarm
- Intelligent Digital Signal processing – differentiates between naturally caused vibrations and cuts out frequencies that cannot be caused by an illegal entry attempt
- Ideal for windows, doors, walls and roofs
- Encapsulated bi-morph piezo electric sensor
- Model name: RK601SM Shocktec™ Plus with Contact